WAr Build Installation located outside the Architecture Department at Wentworth Institute of Technology.
This lamp became a study in parametric design. The lamp was designed using parametric rules in Grasshopper to develop a radial rib structure based on a single profile curve. […]
The assembly of the installation components. Each object was laser cut out of 0.25″ thick acrylic plexi. The Arduino boards were coded and wired to the LEDs, PIR sensor, […]
Testing the Arduino setup allowing the passive infrared sensor to trigger the fan. The setup states that if the PIR sensor detects motion within its set viewing range it will […]
Testing the Arduino setup within the plexiglass structure. The micro controller was coded and wired within the shell connecting to the sensor, the fan, and the LED lights. This […]
Testing the Arduino setup to drive a DC fan. The fan will become an actuator inflating and deflating the ‘skin’ of the object, allowing for various changes in state […]